Adjusting The Front Wheel Static Balance - Yamaha FZ1-N 2007 Service Manual

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys
NOTE:
The wheel sensor rotor of the vehicle is
inserted under pressure by a special process
and cannot be replaced as a single unit. To
replace the sensor rotor, replace the wheel
assembly.
Installing the front wheel sensor
1. Install:
• Front wheel
NOTE:
Align the slot in the sensor housing with the
projection of the front fork before assembly.
ECA14470
CAUTION:
Make sure there are no foreign materials in
the wheel hub. Foreign materials cause
damage to the inner sensor rotor and wheel
sensor.
2. Install:
• Front wheel sensor "1"
Front wheel sensor bolt
7 Nm (0.7 m·kg, 5.1 ft·lb)
• Brake caliper "2"
• Front wheel sensor lead holder "3"
Front brake caliper bolt
40 Nm (4.0 m·kg, 29 ft·lb)
email: info@motomatrix.co.uk
• Brake hose holder "4"
NOTE:
When installing the front wheel sensor, check
the wheel sensor lead for twists and the sensor
electrode for foreign materials.
ECA14480
CAUTION:
To route the front wheel sensor lead, refer
to "CABLE ROUTING" on page 2-39.
3. Check:
• Front wheel sensor installation
Check if the wheel sensor housing is
installed properly.
Refer to "[D-3] MAINTENANCE OF THE
FRONT WHEEL SENSOR AND SENSOR
ROTOR" on page 4-12.
EAS21970
ADJUSTING THE FRONT WHEEL STATIC
BALANCE
NOTE:
• After replacing the tire, wheel or both, the
front wheel static balance should be
adjusted.
• Adjust the front wheel static balance with the
brake disc installed.
1. Remove:
• Balancing weight(s)
2. Find:
• Front wheel's heavy spot
NOTE:
Place the front wheel on a suitable balancing
stand.
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Spin the front wheel.
b. When the front wheel stops, put an "X
mark at the bottom of the wheel.
4-13
FRONT WHEEL
"
1