Yamaha FZ1-N 2007 Service Manual page 14

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys
3. When the hour digits start flashing, push
the "RESET" button to set the hours.
4. Push the "SELECT" button, and the minute
digits will start flashing.
5. Push the "RESET" button to set the min-
utes.
6. Push the "SELECT" button and then
release it to start the clock.
Odometer and tripmeter modes
1. Odometer/tripmeter/fuel reserve tripmeter
Push the "SELECT" button to switch the dis-
play between the odometer mode "ODO" and
the tripmeter modes "TRIP A" and "TRIP B" in
the following order:
TRIP A → TRIP B → ODO → TRIP A
When the fuel amount in the fuel tank
decreases to 3.4 L (0.90 US gal) (0.75
Imp.gal), the left segment of the fuel meter will
start flashing, and the odometer display will
automatically change to the fuel reserve trip-
meter mode "FTRIP" and start counting the
distance traveled from that point. In that case,
push the "SELECT" button to switch the dis-
play between the various tripmeter and odom-
eter modes in the following order:
F-TRIP → TRIP A → TRIP B → ODO → F-
TRIP
To reset a tripmeter, select it by pushing the
"SELECT" button, and then push the "RESET"
button for at least one second. If you do not
reset the fuel reserve tripmeter manually, it will
reset itself automatically and the display will
return to the prior mode after refueling and
traveling 5 km (3 mi).
email: info@motomatrix.co.uk
Fuel meter
1. Fuel meter
The fuel meter indicates the amount of fuel in
the fuel tank. The display segments of the fuel
meter disappear towards "E" (Empty) as the
fuel level decreases. When only one segment
is left near "E", refuel as soon as possible.
NOTE:
This fuel meter is equipped with a self-diagno-
sis system. If the electrical circuit is defective,
the following cycle will be repeated until the
malfunction is corrected: "E" (Empty), "F" (Full)
and symbol " " will flash eight times, then go
off for approximately 3 seconds. If this occurs,
have a Yamaha dealer check the electrical cir-
cuit.
Coolant temperature mode
1. Coolant temperature display
The coolant temperature display indicates the
temperature of the coolant.
Push the "RESET" button to switch the coolant
temperature display to the air intake tempera-
ture display.
NOTE:
When the coolant temperature display is
selected, "C" is displayed for one second, and
then the coolant temperature is displayed.
1-5
FEATURES