Adjusting The Front Wheel Static Balance - Yamaha TMAX XP500F 2015 Service Manual

ECA22380
NOTICE
• Do not drop the speed sensor rotor or sub-
ject it to shocks.
• If any solvent gets on the speed sensor ro-
tor, wipe it off immediately.
• Replace the brake disc bolts and speed
sensor rotor bolts with new ones.
TIP
Install the sensor rotor with the stamped mark
"a" facing outward.
a
A
3. Install:
• Air valve
TIP
• Fasten air valve nut "1" and tighten air valve
locknut "2" to 3.0 Nm (0.30 m·kgf, 2.2 ft·lbf).
• When installing the air valve, orient the air
valve referring to the illustration.
▼ ▼▼▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
a. Tighten the air valve nut "1".
Front wheel air valve nut
2.0 Nm (0.20 m·kgf, 1.4 ft·lbf)
b. Tighten the air valve locknut "2" while holding
the air valve nut so as not to turn the nut.
Front wheel air valve locknut
3.0 Nm (0.30 m·kgf, 2.2 ft·lbf)
▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼▼▼
4-27
a. 45°–55°
A. Wheel rotation direction
B. Left side
▲ ▲▲▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
EAS30152
ADJUSTING THE FRONT WHEEL STATIC
BALANCE
TIP
• After replacing the tire, wheel or both, the front
wheel static balance should be adjusted.
• Adjust the front wheel static balance with the
brake disc installed.
1. Remove:
• Balancing weight(s)
2. Find:
• Front wheel's heavy spot
TIP
Place the front wheel on a suitable balancing
stand.
▼ ▼▼▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
a. Spin the front wheel.
b. When the front wheel stops, put an "X
at the bottom of the wheel.
c. Turn the front wheel 90° so that the "X
is positioned as shown.
d. Release the front wheel.
e. When the wheel stops, put an "X
the bottom of the wheel.
FRONT WHEEL
▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲▲▲
▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼▼▼
" mark
1
" mark
1
" mark at
2