Yamaha FZ1-N 2007 Service Manual page 58

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys
Item
Shift rod locknut (rear)
Shift rod joint bolt
Shift arm bolt
Neutral switch
Sub-throttle servo motor cover
bolt
Coolant temperature sensor
Cylinder identification sensor bolt
Atmospheric pressure sensor bolt
Crankshaft position sensor bolt
Oil level switch bolt
Starter motor bolt
NOTE:
• Cylinder head nut
1 First, tighten the bolts to approximately 19 Nm (1.9 m•kg, 14 ft•lb) with a torque wrench following
the tightening order.
2 Retighten the bolts 67 Nm (6.7 m•kg, 48 ft•lb) with a torque wrench.
• Connecting rod cap bolt
1 Tighten the connecting rod bolts to 20 Nm (2.0 m•kg, 14 ft•lb) and then tighten them further to
reach the specified angle 150°.
• Crankcase bolt (main journal)
1 First, tighten the bolts to approximately 20 Nm (2.0 m•kg, 14 ft•lb) with a torque wrench following
the tightening order.
2 Loosen all the bolts one by one following the tightening order and then tighten them to 20 Nm (2.0
m•kg, 14 ft•lb) again.
3 Retighten the bolts further to reach the specified angle (60°)
email: info@motomatrix.co.uk
Thread
Q'ty
size
M6 1 7 Nm (0.7 m·kg, 5.1 ft·lb)
M6 1 10 Nm (1.0 m·kg, 7.2 ft·lb)
M6 1 10 Nm (1.0 m·kg, 7.2 ft·lb)
M10 1 20 Nm (2.0 m·kg, 14 ft·lb)
M4 3 2 Nm (0.2 m·kg, 1.4 ft·lb)
M12 1 18 Nm (1.8 m·kg, 13 ft·lb)
M6 1 8 Nm (0.8 m·kg, 5.8 ft·lb)
M5 2 7 Nm (0.7 m·kg, 5.1 ft·lb)
M6 1 10 Nm (1.0 m·kg, 7.2 ft·lb)
M6 2 10 Nm (1.0 m·kg, 7.2 ft·lb)
M6 2 10 Nm (1.0 m·kg, 7.2 ft·lb)
2-15
TIGHTENING TORQUES
Tightening torque Remarks
Left
thread
LT
LT
LT