Assembling The Front Wheel; Adjusting The Front Wheel Static Balance - Yamaha XSR MTM690 2016 Service Manual

TIP
Do not touch the surface of the wheel sensor ro-
tor with a sharp object.
c. If the deflection is above specification, re-
move the sensor rotor from the wheel, rotate
it by one or two bolt holes, and then install it.
Front wheel sensor rotor bolt
8 Nm (0.8 m·kgf, 5.8 ft·lbf)
LOCTITE®
ECA18100
NOTICE
Replace the wheel sensor rotor bolts with
new ones.
d. If the deflection is still above specification, re-
place the wheel sensor rotor.
TIP
Install the wheel sensor rotor with the stamped
mark "a" facing outward.
a
A
▲ ▲▲▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
EAS30151

ASSEMBLING THE FRONT WHEEL

1. Install:
• Wheel bearings
• Oil seals
▼ ▼▼▼ ▼ ▼▼▼ ▼
a. Install the new wheel bearing (right side).
ECA18110
NOTICE
Do not contact the wheel bearing inner race
"1" or balls "2". Contact should be made
only with the outer race "3".
TIP
Use a socket "4" that matches the diameter of
the wheel bearing outer race.
b. Install the spacer.
c. Install the new wheel bearing (left side).
TIP
Place a suitable washer "1" between the socket
"2" and the bearing so that both the inner race
"3" and outer race "4" are pressed at the same
time, and then press the bearing until the inner
race makes contact with the spacer "5".
▲ ▲▲▲ ▲ ▲▲▲ ▲
EAS30152
ADJUSTING THE FRONT WHEEL STATIC
BALANCE
TIP
• After replacing the tire, wheel or both, the front
wheel static balance should be adjusted.
▲▲▲
4-16
FRONT WHEEL
New
New
▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼
▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲
▼ ▼▼▼ ▼ ▼▼▼
▲ ▲▲▲ ▲ ▲▲▲