Table of Contents
Advertisement
Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys
1. Check:
• Throttle position sensor
Refer to "CHECKING THE THROTTLE
POSITION SENSOR" on page 8-145.
2. Adjust:
• Throttle position sensor angle
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Connect the throttle position sensor cou-
pler to the wire harness.
b. Connect the digital circuit tester to the
throttle position sensor.
• Positive tester probe
yellow terminal "1"
• Negative tester probe
black/blue terminal "2"
Digital circuit tester
90890-03174
c. Measure the throttle position sensor volt-
age.
d. Adjust the throttle position sensor angle so
the measured voltage is within the speci-
fied range.
Throttle position sensor voltage
0.63–0.73 V
e. After adjusting the throttle position sensor
angle, tighten the throttle position sensor
screws.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
email: info@motomatrix.co.uk
THROTTLE BODIES
EAS5D01025
ADJUSTING THE SUB-THROTTLE POSI-
TION SENSOR
1. Check:
• Sub-throttle position sensor
Refer to "CHECKING THE SUB-THROT-
TLE POSITION SENSOR" on page 8-146.
2. Adjust:
• Sub-throttle position sensor full open angle
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Turn the nut "1" of the worm shaft of the
sub-throttle counterclockwise until it con-
tacts with the full open stopper.
b. When the dimension of "a" sections of the
throttle bodies #3 and #4 is measured with
a micrometer caliper, adjust with the
adjuster "2" of the output shaft section of
the sub-throttle servo motor so that the
dimension is in a range from 24.2 to 24.6
mm (0.95 to 0.97 in.)
Sub-throttle dimension "a"
24.2–24.6 mm (0.95–0.97 in)
c. After adjusting the dimension of "a" sec-
tions of the throttle bodies #3 and #4, mea-
sure the dimension of "a" sections of #1
and #2.
d. If the dimension of "a" sections of the throt-
tle bodies #1 and #2 is different from the
dimension of "a" sections of the throttle
bodies #3 and #4, adjust it to the same
dimension as the measurement value
adjusted for the throttle bodies #3 and #4,
using the tuning screw "3" located between
the throttle bodies #2 and #3.
7-8
Advertisement
Chapters
Table of Contents
