Yamaha FZ1-N 2007 Service Manual page 474

Manuals by Motomatrix / www.motomatrix.co.uk / The Solution For Lost Motorcycle Coded Keys
2. Turn the main switch on.
• The multi-function display indicates previously recorded malfunction codes.
NOTE:
The ABS error code is not displayed during the diagnosis of the fuel injection.
3. Turn the engine stop switch off.
ECA4S81019
CAUTION:
If the starter switch is pushed without turning the engine stop switch off, it may damage the
starting motor gears or other parts, therefore be sure to turn it off.
4. Push the starter switch more than 10 times in 4 seconds to delete the malfunction codes.
NOTE:
If the malfunction codes cannot be cleared, the disconnection of the starter switch monitor leads
could be a cause.
5. Turn the main switch off.
6. Turn the main switch on again.
• Check that the ABS warning light goes on for 2 seconds, then goes out for 3 seconds and starts
flashing.
a. ABS warning light
b. ON
c. Main switch on
d. Main switch off
7. Turn the main switch off.
8. Disconnect the test coupler adapter from the test coupler, and install the protective cap with the
test coupler adapter. Deleting the malfunction code is now finished.
NOTE:
Do not forget to install the protective cap.
ECA5D01004
CAUTION:
Since the ECU remains in the memory until the malfunction code is deleted, always delete
the malfunction code when the service work is finished.
email: info@motomatrix.co.uk
ABS (ANTI-LOCK BRAKE SYSTEM)
e. Flashing
f. 2 seconds
g. 3 seconds
h. 0.5 seconds
8-119