Displaying And Maintaining Ntp; Ntp Configuration Examples; Configuring Ntp Client/Server Mode - H3C S5120-SI Series Operation Manual

The procedure of configuring NTP authentication on a server is the same as that on a client, and the
same authentication key must be configured on both the server and client sides.

Displaying and Maintaining NTP

To do...
View the information of NTP
service status
View the information of NTP
sessions
View the brief information of the
NTP servers from the local
device back to the primary
reference source

NTP Configuration Examples

Configuring NTP Client/Server Mode

Network requirements
The local clock of Device A is to be used as a reference source, with the stratum level of 2.
Device B works in the client/server mode and Device A is to be used as the NTP server of Device
B.
Figure 1-7 Network diagram for NTP client/server mode configuration
Configuration procedure
1) Configuration on Device B:
# View the NTP status of Device B before clock synchronization.
<DeviceB> display ntp-service status
Clock status: unsynchronized
Clock stratum: 16
Reference clock ID: none
Nominal frequency: 100.0000 Hz
Actual frequency: 100.0000 Hz
Clock precision: 2^18
Clock offset: 0.0000 ms
Root delay: 0.00 ms
Use the command...
display ntp-service status
display ntp-service sessions
[ verbose ]
display ntp-service trace
1-15
Remarks
Available in any view
Available in any view
Available in any view