Displaying And Maintaining Habp; Habp Configuration Example - H3C S5120-SI Series Operation Manual

To do...
Configure HABP to work in
client mode

Displaying and Maintaining HABP

Display HABP configuration information
Display HABP MAC address table entries
Display HABP packet statistics

HABP Configuration Example

Network requirements
As shown in Figure
B and Switch C. Configure HABP so that Switch A can manage Switch B and Switch C.
Configure Switch A as the HABP server, allowing HABP packets to be transmitted in VLAN 2.
Enable HABP client on Switch B and Switch C.
On switch A, set the interval to send HABP request packets to 50 seconds.
Figure 1-2 Network diagram for HABP configuration
Configuration procedure
1) Configure Switch A
Use the command...
undo habp server
To do...
1-2, Switch A is the management device and connects two access devices: Switch
Use the command...
display habp
display habp table
display habp traffic
1-3
Remarks
Optional
HABP works in client mode by
default.
Remarks
Available in any view
Available in any view
Available in any view