Canon Laser Class 810 Basic Operation Manual page 370

SYSTEM SETTINGS
2. STATELESS ADD SET Sets whether to automatcally specfy a stateless address upon
3. MANUAL ADD SET
1. USE MANUAL
ADD
OFF
ON
2. MANUAL
ADDRESS
3. PREFIX LENGTH
4. DEF. ROUTER
ADD
4. USE DHCPv6
5. PING COMMAND
1. PING
COMMAND
2. HOST NAME
6. SET IP ADD RANGE
OFF
ON
12-40
startup.
– OFF
– ON
Allocates an IPv6 address to the machne manually.
Sets whether to set a fxed IPv6 address to the machne.
A fxed IPv6 address s not set.
Sets a fxed IPv6 address to the machne.
Regsters a fxed IPv6 address to the machne.
Sets the prefx length of the IPv6 address. (0-128)
Sets the default router address.
Sets whether to set to obtan a stateful address from a DHCP
server usng DHCPv6.
– ON
– OFF
Enables you to check whether the machne can connect to a
devce on the network.
Enter the IPv6 address of a devce on the network and press
[OK] to check whether the machne can connect to that devce.
Enter the host name of a devce on the network and press [OK]
to check whether the machne can connect to that devce.
Sets whether to restrct the range of IP addresses.
Dsables restrcton of IP address of computers.
Enables you to set whch IP addresses can send data (prnt/fax
jobs) to the machne. You can select to permt or reject up to
ten ranges of IP addresses. Set each range of IP addresses by
enterng an IP address n both <START IP ADDRESS>, <END IP
ADDRESS> and <PREFIX LENGTH>.
– 1. IP ADDRESS 1
– 2. IP ADDRESS 2
– 3. IP ADDRESS 3
– 4. IP ADDRESS 4
– 5. IP ADDRESS 5
– 6. IP ADDRESS 6
– 7. IP ADDRESS 7
– 8. IP ADDRESS 8
– 9. IP ADDRESS 9
– 10. IP ADDRESS 10