How To Use The Envelope Feeder Attachment - Canon iR 3300 Reference Manual

How to Use the Envelope Feeder Attachment

How to Use the Envelope Feeder Attachment

How to Use the Envelope Feeder Attachment How to Use the Envelope Feeder Attachment
The following six types of envelopes can be loaded into the Envelope Feeder Attachment:
COM10, Monarch, DL, ISO-B5, ISO-C5 and Yougata 4. The main unit and the Envelope Feeder
Attachment are set so that COM10 envelopes can be loaded without any adjustment.
When using COM10 envelopes, load them (See 'Loading Envelopes,' on p. 7-19.) after checking
the following:
- "COM10" is selected for "ENV. 1" with "Additional Functions" → "Common Settings" →
"Envelope Cassette" screen.
- The guides are adjusted to hold COM10 envelopes.
- The size switch is set to <ENV. 1.>
IMPORTANT
• • • •
Do not print on both sides of the envelope. Doing so may cause a paper jam, dirty prints, or dirt
accumulation inside the machine.
• • • •
Do not load the following envelopes inside the envelope cassette. Doing so may cause a paper jam,
dirty prints, or dirt accumulation inside the machine.
- Heavily curled, creased, or folded envelopes
- Very thick or thin envelopes
- Damp or wet envelopes
- Torn envelopes
- Irregularly shaped envelopes
7 7 7 7
- Envelopes with clasps or windows
- Envelopes with seals closed with glue or other substances
- Envelopes with holes or perforations
- Envelopes with specially coated surfaces
- Envelopes made of surface-treated coloured paper
- Envelopes which use ink, glue, or other substances which can melt, burn, vaporize, or emit noxious
• • • •
Envelopes are output into Tray B when the Saddle Finisher-G1 is attached, and into Tray A when the
Inner 2way Tray-A1 is attached, even when a dedicated tray is specified.
• • • •
When printing on envelopes, empty the output tray when at most 10 printed envelopes accumulate
in the tray.
• • • •
Envelopes should be stored in a place away from high temperatures and humidity.
• • • •
If there is a marked temperature difference between the location where the envelopes were stored
and the location where the envelopes are to be printed, leave the envelopes in the printing location
at room temperature before use.
Correctly match the size switch and settings with Additional Functions → "Common Settings" to the
• • • •
envelope being loaded. Failure to do so may cause a paper jam or dirt accumulation inside the
machine.
7-16 7-16 7-16 7-16 Envelope Feeder Attachment-B1
gases under the heat of a fixing unit (approximately 200° C). Depending on the materials used for the
seal, the glue may melt under the fixing unit's heat, sealing the envelopes.