How to Use Media Edge Protectors
[76] Media Edge Detector Height Adjustor
IMPORTANT
If the height adjustor area is higher than 1 mm from the platen, there is a possibility that the
carriage may hit the edge of the protector and thus damage printhead nozzles.
4.
Peel the backing layer from the double-sided tape on the back of the protector.
5.
Place the bent edge of the protector into the media cut guide, but do not press down on the tape
yet.
6.
Slide the protector towards the media edge until the inside edge of the height adjustor is
positioned over the media edge (see figure below).
NOTE
Do not let the plastic edge near the arc butt up against the media edge or the device may not let
the media pass smoothly.
The vacuum in the platen will hold the main part of the protector in place while the image is
printed.
7.
Press down on the tape to fasten the protector in this position.
[77] Edge Protector in Position
NOTE
The adhesive on the edge protector can be re-used approximately ten times. If you find that it is
not holding the protector in place, then use a new one.
112
Chapter 7 - How to Operate the Roll Media Option
Océ Arizona 600 Series