How To Power On - Oce Arizona 640 GT User Manual

How to Power ON

Introduction
This section describes how to switch the printer On and Off. When the printer is switched On, the
interface software is displayed on the LCD monitor that is located on the Operator Control
Station. From there the operator can access and control the printer. We recommend that you
leave the printer powered on at all times. However, if the printer is switched Off for extended
periods, there are procedures to follow that are documented here.
Before you begin
Before you apply AC power to the printer, make sure that loose objects such as clothing, tools
and cleaning materials are not interfering with the printer mechanisms. Position the power cord
so that it does not pose a hazard when walking around or moving media or other objects near the
printer. The printer has an AC power switch that turns the printer On or Off. The switch also
functions as an AC power lock-out switch. It is located at the end of the printer, as seen below.
NOTE
Some printer models may have a different type of AC power plug than what is shown in the
photo. See the Site Preparation guide for a photo of the two types of power plugs.
CAUTION
THE SOCKET OUTLET MUST BE INSTALLED NEAR THE EQUIPMENT AND BE EASILY
ACCESSIBLE. Ensure that you follow the guidelines in the Site Preparation Guide before
plugging the printer AC power plug into the socket.
IMPORTANT
Unplug the AC power cord from the printer to completely isolate the electronics of the printer,
especially when you move or service the printer.
Procedure
1.
Ensure that the AC power plug is properly seated.
2.
Turn on the AC power On/Off switch.
3. If it is not already on, turn on the power of the Control Station LCD monitor.
4. During the boot-up procedure, the printer software is automatically started. The software displays
a splash screen followed by a screen that requests you to raise and then lower the carriage guard.
5.
Lift the carriage guard slightly and then replace it. At the control station click on Continue to finish
the startup procedure.
Océ Arizona 600 Series
Chapter 5 - How to Operate Your Océ Arizona Printer
How to Power ON
63