Oce Arizona 640 GT User Manual page 58

Tools and Utilities Module
That special print is now available in the Active job list of the Print Job Control module.
How to Print a Special Print
Go to the Print Job Control module to actually print the special print. It will appear in the active
job list and is printed like any other print job.
NOTE
Refer to the sections that document the special prints for details on printing. For example, the
Nozzle check and the Ship print are printed on I/O paper, while the Ruler Guide Print is printed
directly on the table. Note that some of the special prints are meant for service technicians only
and are not for use by the printer operator.
The Ink Flush Procedure
The Ink Flush Procedure is used when the printer is switched from one ink type to another. If you
insert a new ink bag of a different ink type into the ink bay, the Ink Status screen will appear and
prompt you to perform an Ink Flush Procedure. The Ink Flush Procedure will prompt you to
perform either:
1) Short flush procedure - this is performed when switching to a compatible ink type; or
2) Full flush procedure - this is performed when switching to a an ink type that is not compatible
with the current ink used. In this case an ink flush kit is required.
NOTE
Contact your local service representative for information about this ink flush kit. Only inks
certified by Océ can be used with your printer.
Spit Catcher Alignment Procedure
A Spit Catcher is necessary for all printers with the white ink option installed or for any printer
that uses the Océ ICJ256 inks. The Spit Catcher consists of a slotted cover for the Maintenance
Station drawer and a foam pad that is held in place under the drawer. Both the white ink and all
of the IJC256 inks need to "spit" periodically to help keep the printhead nozzles clear of debris.
The Alignment Procedure is needed when the Spit Catcher is first installed or if for some reason
the park position of the carriage changes. The purpose of the alignment is to have the carriage
parked directly over the slots in the spit catcher so that the ink that is spit falls though the slots
and is soaked up by the foam pad below. If you see a buildup of ink on the surface of the spit
catcher it may mean you need to follow the alignment procedure.
NOTE
The foam pad must be changed if it becomes too saturated with ink. It is a commercial item so
see your local representative for replacements.
System Logs
The System Logs are raw data log files for service diagnostics and troubleshooting purposes.
They are meant for service technicians only. Generate system logs only when requested by an
Océ service technician and follow the instructions they provide for retrieval of the files.
NOTE
When System Logs are generated, any previously saved log files are deleted. Therefore, do not
generate a second batch if you have just recently generated log files (unless requested to do so
by a service technician).
58 Chapter 4 - How to Navigate the User Interface
Océ Arizona 600 Series