Oce Arizona 640 GT User Manual page 87

6.
Place media in Zone B, mask off any unused areas, and turn On the vacuum. The printer will
pause over the Center Zone after the Zone A print is complete and then start to print in Zone B.
NOTE
The printer will not print in Zone B if the vacuum is not On. It will display "Waiting for Table
Vacuum" and wait in the Center Zone until the vacuum is On and then will also require that you
press the Start button. The vacuum must be cycled Off and then On again in alternating zones
before the next print will begin while Dual Origin is enabled.
7.
If additional copies of the print were indicated in Step 2, then repeat Steps 5 to 7 (in alternate
zones) for the total number of prints required.
Result
NOTE
The green arrows show the order in which images are printed in Zones A & B when Dual Origin
was selected.
Océ Arizona 600 Series
Chapter 6 - How to Operate the Océ Arizona 600 Series XT
How to Print With Dual Origins
87