Regency Bellavista B41XTCE-NG10 Owners & Installation Manual page 48

installation
|
48
OPTIONAL WALL THERMOSTAT INSTALLATION
A wall thermostat may be installed if desired.
Recommended: The Wall Thermostat should be mounted beside the Re-
mote/Unit Receiver which comes standard with the appliance.
1) Run wires from thermostat into the unit.
2) Remove the green wire marked (TH) at the white connector-shown
below. The noted wires will be located near the gas valve.
Green Wires
Disconnect greenTH wire
3) Connect one thermostat lead to female connector, using male spade con-
nector - see picture below.
48 |
Regency Bellavista™ B41XTCE-10 Gas Fireplace
White Connector
4) Connect the other thermostat lead to male connector disconnected
from Step1using a female spade connector - see picture below.
When complete turn remote receiver to the ON position.
Unit will now operate using the wall thermostat.
NOTE: When the remote receiver is set to ON position, the remote
control transmitter and all of its features are now disabled.
CAUTION
Do not wire
Thermostat wires
to 120V wire.