Regency Bellavista B41XTCE-NG10 Owners & Installation Manual page 15

7. Non-combustible material (ie. tile, slate, etc) may be brought up to the edge of the glass door of the unit. Minimum clearances must be adhered to, this
will assure ease of glass door removal and access to the lower panel.
NOTE: Non-combustible finishing materials may be of any thickness desired.
46-11/16"
[1186mm]
NON-COMBUSTIBLE BOARD SUPPLIED W/UNIT
No Combustible
Materials in this Area
NO FACING OR
FINISHING MATERIAL
IN THIS AREA
38-7/16"
976mm
4-1/8"
[105mm]
Minimum Clearances for Finishing Materials
IMPORTANT FINISHING DETAIL NOTE:
Before placing unit into final position - it is important to know the total
thickness / height of finished hearth (tile, carpet, etc.) The base of the
fireplace, 4 sided faceplate or mantel should be level or higher than the
finished hearth height.
6" [152mm]
11-5/8"
[295mm]
3-9/16"
[91mm]
Note:
Rough edges may be visible from an angle.
To maintain a clean finished edge - facing material edges
IMPORTANT: Materials used must be NON-COMBUSTIBLE.
No Combustible
Materials in this Area
J Style trim or metal
corner bead may be
used to finish edges
38-7/16"
976mm
Trim materials
All non-combustible facing material should butt up cleanly
to the flanges around the firebox opening.
may be finished with a J-style trim or metal cornerbead (both
materials available at your local building or hardware store).
Regency Bellavista™ B41XTCE-10 Gas Fireplace
installation
|
15
| 15