Regency Bellavista B41XTCE-NG10 Owners & Installation Manual page 18

installation
|
18
8) From the outside top of the firebox - completely remove the insulation
under the cover plate as shown and discard.
9) From the outside back of the firebox - locate the insulation deflector
and bend completely upwards flat against the back of firebox.
IMPORTANT: If the insulation deflector is not bent flat against the back of
the firebox this will block air intake which will affect the unit's performance.
View Front of Firebox
10) From the inside of the firebox, place the exhaust assembly into position
as shown in Diagram 1 and secure with 10 - 1/4" x 1/2" screws (Diagram
2). Ensure all screws are tight, but do not over tighten.
All 10 screws must be used.
Diagram 1
Diagram 2
18 |
Regency Bellavista™ B41XTCE-10 Gas Fireplace
Insulation Deflector
11) From the outside top of the firebox, install the intake collar assembly.
Secure with 4 - 1/4" x 1/2" screws. Ensure all screws are tight, but do not
over tighten. All 4 screws must be used.
12) From the outside rear of the firebox, install the intake cover plate with
4 - 1/4" x 1/2" screws. Ensure all screws are tight, but do not over tighten.
All 4 screws must be used.
13) Set vent restrictor accordingly - see next page.
14) From inside the firebox, re-install the baffle plate from step 2.
15) From inside the firebox, reinstall the top heat deflector by placing 2 screws.
Heat Deflector
16) From inside the firebox, reinstall the baffle plate by placing 4 screws -
replace top front screw first. Leave loose - until rear screws installed.
See Diagram 3.
Baffle Plate
Note: Reuse existing screw holes - do not make new holes. Tighten screws.
Exhaust
Assembly
Intake Collar
Assembly
Diagram 2
Diagram 3