Optional Black Enamel Panel Installation - Regency Bellavista B41XTCE-NG10 Owners & Installation Manual

OPTIONAL BLACK ENAMEL PANEL INSTALLATION

• Black Enamel panels must be inspected for scratches and dimples prior to installation. All claims to be recorded at this time.
Claims for damage after installation will not receive consideration.
• Black Enamel panels will discolor a little during normal operation. This is normal and should not be considered a defect.
*
All hand and fi nger marks MUST be cleaned off with a soft cloth. Use an ammonia based cleaner (ie. glass cleaner) to remove any
fi ngerprints before applying heat to the unit.
Failure to do this will result in burn stains on panels which you will be unable to remove. Not protected by product warranty.
1) Prior to installation of the refl ective panels, remove the top panel
bracket currently fi tted into the baffl e opening on the inside top of
the fi rebox. See diagram below.
918-866b
OPTIONAL BLACK ENAMEL
PANEL INSTALLATION
Black Enamel Panels
Note: Panels must be installed prior to the installation of the log set and vermiculite.
TOP
LEFT
BACK
Top Panel Bracket
RIGHT
2) Install the back stainless panel fi rst - be careful not to scratch the
panel on the burner or log tray when installing. Ensure the back
panel is centered when installed.
3) Install the right side panel - secure with panel clip and 1 screw.
See step 3.
Back Panel
Regency Bellavista™ B41XTCE-10 Gas Fireplace
1
B41XT
installation
|
Right Side Panel
05/29/12
37
| 37