Table of Contents
Advertisement
Dial Pulse Setting
Dial Pulse Type
Tone Signal
Transmission Time
Length
Minimum Pause In
Tone Dialing
Attenuator For
Pseudo Ring
Backtone To the
Tone Signal Settings
Line
DTMF Level
DTMF Delta
Wait Time
1Dial Tone
Detection
Timeout Length
This sets the number of pulses that are generated during
dialing.
• N: Dialing '0' generates 10 pulses --- Dialing '9'
generates 9 pulses.
• N+1: Dialing '0' generates 1 pulses --- Dialing '9'
generates 10 pulses.
• 10-N: Dialing '0' generates 10 pulses --- Dialing '9'
generates 1 pulse.
Sets the tone signal transmission time length
[100 ms (Default)]
Sets the minimum pause during tone dialing
[100 ms (Default)/ 150 ms/ 200 ms]
Sets the attenuator for pseudo ringback tone to the line
[0 to 15 / 10 (Default)/ 1 dB/step]
Sets the transmission level of DTMF tones.
[-12 dBu / -11 dBu/ -10 dBu/ -8 dBu/ -6 dBu]
Sets the level difference between high band frequency
signals and low band frequency signals when sending
DTMF tones.
[2 dBu/ 3 dBu]
The machine starts dialing after the specified interval without
detection of a dial tone when
Dial tone detection is set to "No detection".
[3.5 Sec (Default)/ 7.0 Sec/ 10.5 Sec
/ 14.0 Sec]
This setting sets the time-out length for the 1st dial tone
detection. The machine waits for a dial tone for the specified
time and disconnects itself from the line when no dial tone
is input.
[10 Sec (Default)/ 15 Sec/ 20 Sec/ 30 Sec]
Service Menu (MF Model)
147
5
Advertisement
Table of Contents
