Ricoh PE-P1 Service Manual page 144

2nd Transfer Back
Fuser Temperature
Horiz. Tray1
Vert.Tray1
Horiz.Tray2
Vert.Tray2
Registration
Horiz.Bypass
Vert.Bypass
Horiz.Dup.Back
Adjusts the transfer roller current, based on the default
value.
[-15 to 15 / 0 (Default) / 1 μA/step]
Adjusts the temperature of the fusing unit, based on the
default value.
[-30 to 0 / 0 (Default) / 2°C/step]
Adjusts the horizontal registration for tray 1. If the machine
settings are reset to the factory defaults, this value does not
change.
[-15 to 15 / 0 (Default) / 4 mm/step]
Adjusts the vertical registration for tray 1. If the machine
settings are reset to the factory defaults, this value does not
change.
[-15 to 15 / 0 (Default) / 0.24 mm/step]
Adjusts the horizontal registration for tray 2. If the machine
settings are reset to the factory defaults, this value does not
change.
[-15 to 15 / 0 (Default) / 4 mm/step]
Adjusts the vertical registration for tray 2. If the machine
settings are reset to the factory defaults, this value does not
change.
[-15 to 15 / 0 (Default) / 0.3 mm/step]
Adjusts the horizontal registration for the bypass tray. If the
machine settings are reset to the factory defaults, this value
does not change.
[-15 to 15 / 0 (Default) / 4 mm/step]
Adjusts the vertical registration for the bypass tray. If the
machine settings are reset to the factory defaults, this value
does not change.
[-15 to 15 / 0 (Default) / 0.3 mm/step]
Adjusts the horizontal registration for the back side in
duplex mode. If the machine settings are reset to the factory
defaults, this value does not change.
[-15 to 15 / 0 (Default) / 4 mm/step]
Service Menu (MF Model)
143
5