Table of Contents
Advertisement
8. Select "Model", and then select a model.
9. Select "PnP Name", and then select a plug and play name.
10. Select "LSU Adjustment", and then input the LSU (laser optics housing unit) setting values.
11. Turn off the machine.
12. Turn on the machine with the front cover open.
13. Enter "Engine Maintenance" in the "Maintenance Mode Menu" again.
14. Close the front cover.
15. Select "Trans. Belt Adjust", and then execute "Trans. Belt Adjust" to adjust the ITB (Image Transfer Belt)
unit.
16. Select "Fuser SC Detect", and then select "ON" or "OFF" for the consecutive fusing jam detection.
• The default setting is "OFF". Select "ON" only if the customer wants to use this feature.
17. Select "Registration", and then adjust the registration for each direction (vertical and horizontal
direction) and tray if necessary.
18. Select "2nd Transfer Fuser Temp", and then adjust the transfer roller bias and the temperature reduction
of the fusing unit for each paper type and for the front and back sides. The default settings for normal
operation are all '0'.
19. Exit "Engine Maintenance".
Electrical Components
3
77
Advertisement
Table of Contents
