Fuji Xerox DocuPrint C3290 FS User Manual page 115

Setting the Copy Margins
You can set the copy margins and enable the margin settings for all copies, or you can enable them for
individual copy jobs only.
Setting the Margins
1. On the control panel, press the System button.
2.
Select Default Settings
3. Select
Copy Defaults
4. Select
Margin Width
5.
Select the margin that you would like to change, and then press the OK button.
6.
Use the Up Arrow or Down Arrow button to adjust the margin, and then press the OK button.
7.
Repeat the steps for other margins, and then press the Exit button.
8.
You can now use the margin settings for a single copy job, or you can enable the margin settings for all
jobs. To use the margin settings for a single job, see
Single Job on page 6-11. To enable the margin settings for all copy jobs:
a. Select , and press the OK button.
Margin
b. Select , and then press the OK button.
On
The Margin setting is now enabled for all copy jobs.
Note: The margin width is only enabled when copying from the document glass.
Copying with the Margin Settings Enabled for a Single Job
1.
Place the document to be copied on the document glass.
2.
On the control panel, press the Copy button.
3.
Select , and then press the OK button.
Margin
4.
Select , and then press the OK button.
On
5.
Press the Start button to begin copying.
, and then press the OK button.
, and then press the OK button.
, and then press the OK button.
Copying with the Margin Settings Enabled for a
6-11
Adjusting Copying Options