Operation; Projector Led Status Indicators; Turn The Projector On; Turn The Projector Off - Christie Mirage 4K25 Setup Manual

Operation

This section provides information and procedures for turning the projector on and off.

Projector LED status indicators

LED
Solid Green
Solid Yellow
Solid Green, Yellow and Red
Flashing Green
Flashing Yellow
Flashing Red
Flashing Green and Yellow

Turn the projector on

Warning! Failure to comply with the following could result in death or serious injury.
• Do not attempt to turn the projector on if the AC supply is not within the specified voltage range.
1. Set the breaker switch on the projector baseplate to the on position.
2. When the projector reaches standby, on the touch panel controller, tap Home > Power.
Mirage 4K25 Setup Guide
020-101362-02 Rev. 1 (01-2015)
State
On
Standby mode
AC is on
Warm up
Cool down
Alarm or warning preset
AC on to standby
Description
Video electronics are on, the lamp is on.
Video electronics are off, lamp is off.
MCPU board software has not started initialization.
Video electronics are initializing, lamp is striking and
warming up.
Lamp is off, video electronics and lamp are cooling
down.
Problem with the projector must be addressed.
MCPU board software has started initialization.
34