Installing The Reel Motors - Toro Reelmaster 5610-D Operator's Manual

Installing the Reel Motors

1. Grease the reel-motor spline shaft.
2. Oil the reel motor O-ring and install it onto the motor flange.
3. Install the motor
4. Rotate the motor counterclockwise until the flanges encircle the bolts, and then tighten
the bolts.
Ensure that the reel motor hoses are not twisted, kinked, or at risk of being pinched.
5. Torque the mounting bolts to 37 to 45 N∙m (27 to 33 ft-lb).
Setup: Installing the Cutting Units
by rotating it clockwise so that the motor flanges clear the bolts
G411002
IMPORTANT
Page 3–11
.
3464-486 A