5. Other
5.3.16
Waste toner near full detect board/LED (WTDTB/LED)
1. Remove the high voltage unit.
See P.44
[1]
[2]
46
[2]
[3]
[4]
4139fs2030c1
[1]
[2]
[1]
4139F2C597DA
[1]
4139F2C598DA
Field Service Ver. 1.0 Aug. 2007
2. Remove the screw [1], unhook the
tab [2], and remove the wiring saddle
[3]. Then, remove the shield [4].
NOTE
• When reinstalling the shield, use
care not to allow the harness to be
wedged in it.
3. Remove three tabs [1] and the waste
toner near full detect board/LED [2].
4. Disconnect the connector [2] of the
waste toner near full detect board/
LED [1].