Vertical summit Operation Manual page 283

Summit & Summit 800
Feature Description and Operation Manual
SLT
To register Wake-Up
1. Lift the handset.
2. Dial "561", the SLT Programming code, confirmation tone is heard.
3. Dial "41", the set Wake-up code.
4. Dial the 2-digit hour and 2-digit minute for alerting.
5. For a daily (repeating alarm), dial "#".
6. Hook flash, conformation tone is provided.
To stop the alarm notification
1. Lift the handset.
To erase Wake-Up
1. Lift the handset.
2. Dial "561", the SLT Programming code, confirmation tone is heard.
3. Dial "42", the erase Wake-up code.
4. Hook flash, a conformation tone is provided.
Conditions
1. In cases where a remote device is installed, the time display in the remote terminal is
adjusted by the Device Zone assignment. Thus, the Wake-up alarm time is based on
the time displayed on the phone and not the system time.
2. When receiving a Wake up signal, lifting the handset will return MOH.
3. The Wake-Up alarm signal is the station ring signal with a 30 seconds On and 90
seconds Off cycle 3 times. If no action is taken by you to terminate the alarm, the
Attendant is notified with a display of the station number that did not respond.
4. Time must be entered in the Military 24-hour format (hh:mm).
5. The daily alarm will reset and repeat each day until erased (cancelled). The One-time
alarm will reset and cancel automatically.
6. A System announcement can be recorded and assigned to play when the user
responds to the wake up alarm.
Programming
Keyset Admin.
STATION
Web Admin.
STATION DATA
Related Features

Enhanced Wake-up Alarm
Hardware
Wake Up Announcement (PGM 114-Button 24-6)
VM Attributes Wake-Up Announcement
272
Issue 1.2