Table of Contents
Advertisement
Summit & Summit 800
Feature Description and Operation Manual
Press the [SPEED] button and dial the desired bin number.
5. Replace the handset, return to idle.
To deactivate Call forward
1. Press flashing [FWD] button, Call Forward will deactivate and the [FWD] button LED is off.
Or, for an iPECS IP Phone,
1. Lift the handset or press the [SPEAKER] button to receive dial-tone,
2. Press the [FWD] Soft button. For the LIP8002, the [DND] button is used to activate
Forward.
3. Press the # dial pad button.
SLT
To activate Call Forward,(Unconditional, Busy, No Answer, or Busy/No Answer)
1. Lift the handset to receive dial tone.
2. Dial the Call Forward feature dial code "554"
3. Dial desired Call Forward code ("1"~"4").
4. Dial the destination station, station group, or dial CO access code (9, 8xx, 88xx) and
desired external phone number.
5. Momentarily press the hook-switch and receive confirmation tone.
6. Replace the handset to return to idle.
To deactivate the Call forward
1. Lift the handset and receive stutter dial-tone,
2. Dial the Call Forward feature dial code "554",
3. Dial "#" to cancel Call Forward.
Conditions
1. To use Call Forward, a station must be permitted to forward calls in the system
database.
2. Authorization codes are required for 'Follow-me' Call Forward and may be required to
activate Network Call Forward 'Follow-Me'
3. A station is separately allowed Call Forward and Off-Net Call Forward.
4. The iPECS does not check the status of the receiving destination; once forward is
activated, the receiving system is responsible for routing the call.
5. Incoming analog CO lines must provide Disconnect Supervision and the Open Loop
Detect timer must be set for proper operation.
6. Station calls may automatically forward using Preset Call Forward or may forward to
your integrated Voice Mailbox. If the Preset Call Forward timer is shorter than the Call
Forward No-Answer timer, calls will not forward over the network.
7. Network Call Forward 'Follow-Me' can only be deactivated at the original station.
8. Network Call Forward Follow-Me is only available when employing H.323/H.450
networking. When employing Qsig, Call Forward 'Follow-me' is not available over the
network.
9. For proper operation of Call Forward Follow-Me, all systems in the network must
employ the same type of Authorization codes.
10. Call Forward Follow-me is not available between networked systems.
248
Issue 1.2
Advertisement
Table of Contents
