Vertical summit Operation Manual page 212

Summit & Summit 800
Feature Description and Operation Manual
6. Dial auxiliary data as desired.
7. Press the [HOLD/SAVE] button.
To cancel active Display Messages for other stations
1. Press the [TRANS/PGM] button.
2. Dial "052", Attendant Display Message Cancel code.
3. Dial the station range, for a single station dial the same station number twice.
4. Press the [HOLD/SAVE] button.
To enter a System-wide Custom Message
1. Press the [TRANS/PGM] button.
2. Dial "053", the System-wide Custom Message program code.
3. Dial desired Message code ("11"-"20").
4. Enter the Message contents, up to 24 characters.
5. Press the [HOLD/SAVE] button, confirmation tone is received, the new Custom Message is
stored and the station returns to idle.
Conditions
1. Only the System Attendant or Administrator can assign the contents of Custom
Messages 11-20.
2. The alphanumeric characters are displayed as they are entered; refer to Station Speed
Dial for entry procedures.
3. Display Message is cancelled if you activate DND or Call Forward.
4. Custom Text Display Messages and Display Message status are stored in non-volatile
memory to protect against loss during power failure.
5. The calling station must be an iPECS IP or LDP Phone with display to receive the
message.
6. SLTs are notified of an active Display Message with stutter dial tone. The iPECS IP
and LDP Phones will have a flashing [FWD] button when Text Display Message is
active.
7. Activating Text Display Message does not affect normal operation of the station.
8. Pre-defined Messages 01 to 04 and 06 to 08 permit you to input auxiliary information
such as time, date or number.
9. The Attendant station can activate Text Display Messages for other stations. However,
the Text Display Message feature is not available to an Attendant.
Programming
Related Features

Silent Text Message

DND (Do Not Disturb)

Call Forward

Speed Dial
Hardware

iPECS IP or LDP Phone required to receive Display Messages
201
Issue 1.2