Setting Options - Swisscom Top E604 ISDN User Manual

Setting options

You can switch between the settings Standard dial (factory setting), Auto keypad and
Dial * and #.
Standard dial
Once Standard dial has been activated, * and # are not transmitted during dialling, and
if * and # are entered it is not possible to switch to the keypad.
Auto keypad
Once * or # has been entered, this setting automatically transfers ringing during dialling
to the keypad. This automatic switchover is needed for giving commands to the
exchange or PABX.
Dial * and #
Once Dial * and # has been activated, the * and # characters are transmitted during
dialling as commands to the exchange or PABX.
Regardless of the setting options above, after dialling or during the conversation, the
phone switches automatically to tone dialling (DTMF), e.g. for remote control of an
answering machine.
i
s
Set base
s
Settings
~
OK
s
System settings
s
Spec. function
s
Dial properties
s
Standard dial
Activating/deactivating the keypad during a call
In addition to the ongoing settings described above, you can also switch over
temporarily to the keypad.
The setting is only applicable to the current external call and is automatically
deactivated after the call is ended.
i
either ...
s
Keypad on?
~
or ...
s
Keypad off?
Operating when connected to a PABX
Open the menu.
Select the menu item and confirm.
OK
Select the menu item and confirm.
OK
Enter system PIN if required (page 89).
Select the menu item and confirm.
OK
Select the menu item and confirm.
OK
Select the menu item and confirm.
OK
Select the setting and confirm, e.g. Standard dial
OK
‰
( = activated).
Open the menu.
Activate the keypad:
Select the menu item and confirm.
OK
Enter the keypad code.
Deactivate the keypad:
Select the menu item and confirm.
OK
123