Swisscom Top E604 ISDN User Manual page 123

Registering a repeater V2
Precondition: Gigaset Repeater V2 has been deactivated (mains cable unplugged).
1. Prepare the base station for registration:
i
s
Set base
s
Settings
~
OK
s
Setup user
s
Register device
The base station is ready for registration for as long as Registration
proced.running is shown in the display.
Check that there are no other base stations that are ready for
i
registration in the vicinity of the Gigaset Repeater V2 during this
procedure.
2. Plug the Gigaset Repeater V2 into the mains. The LED on the Gigaset repeater V2
flashes. After a short while the LED lights continuously. This indicates that registra-
tion has been completed and the repeater is ready for use.
Further information is available in the operating instructions for the Gigaset Repeater
V2.
Open the menu.
Select the menu item and confirm.
OK
Select the menu item and confirm.
OK
Enter system PIN if required (page 89).
Select the menu item and confirm.
OK
Select the menu item and confirm.
OK
Operating with other devices
121