Swisscom Top E604 ISDN User Manual page 101

Activating/deactivating internal call diversion
Requirement: Internal call diversion can only be activated if a destination has been set
up.
i
s
Set base
s
Int. call forw.
~
OK
either ...
Activate?
or ...
Deactivate?
Defining the number of rings
When ring delay is used, the number of rings before the call is diverted must be defined.
Between 0 (= immediate call diversion) and 9 rings can be set. There are 5 seconds
between rings.
The factory default setting is 0 rings (= immediate call diversion).
i
s
Set base
s
Forward. base
~
OK
s
No. of rings
~
j
Diverting calls externally – CF (Call Forwarding)
For each receive MSN you can store a destination number for each of the following
conditions:
–
Immediately On busy
If call divert is carried out on the base station (internal) (page 102),
◆
the condition
i
All three conditions can be activated at the same time.
◆
If Night service has been set up for a receive MSN (page 85), external
◆
call divert cannot be set up or changed for this receive MSN.
Set up external call diverts are entered in a list. Active call diverts are identified in this
list.
When the phone is supplied external call divert is not set.
Open the menu.
Select the menu item and confirm.
OK
Select the menu item and confirm.
OK
Enter system PIN if required (page 89).
Activate:
Confirm.
OK
Deactivate:
Confirm.
OK
Open the menu.
Select the menu item and confirm.
OK
Select the menu item and confirm.
OK
Enter system PIN if required (page 89).
Select the menu item and confirm.
OK
Enter the number of rings and confirm.
OK
Hold down (back to idle status).
–
On no reply
is not available.
On busy
System settings
99