Preparation For Installation - HIKVISION US-4 Installation Manua

4 Inch Speed Dome Installation Manual V2.0.0
1. Basic requirements
1) All the electronic operation should be strict compliance with the local electrical safety regulations, fire prevention
regulations and other related regulations at the installation place.
2) Check whether all the accessories are there according to the packing list, make sure that the place and installation mode are
conform to the demands, if not, please contact the supplier.
3) Please use this product according to the working environment.
2. Check installation space.
Make sure the place have enough space to install the speed domes and its accessories.
3. Check the intensity of conformation at the installation scene.
Please make sure that the endure ability of ceilings or walls is 4 times as the weight of speed dome and its accessories.
4. Preparation of cables

Choose the video cable according to the transmission length. The video should meet the least demands as:
1. 75Ω resistance
2. 100% copper core conducting wire.
3. 95% weaving copper shield.
 RS485 communication cable, please refer to Appendix 2
 24V AC power cable, please refer to Appendix 3
5. Please keep all wrappers
Please keep all wrappers after unpack them for future use. In case of any failure occurred, please return the speed dome to the
factory with the original wrapper.
Transportation without the original wrapper may result in damage on the speed dome and cost additional charge.
Note:

Preparation for Installation

3