Installation Preparation - HIKVISION DS-2CE16D0T-VFIR3E User Manual

1.2.4 Type IV Camera Overview
Black Liner
Figure 1. 4 Type IV Camera Overview
2.1

Installation Preparation

Before you start:
Make sure that the device in the package is in good

condition and all the assembly parts are included.
Make sure that all the related equipment is power-off

during the installation.
Check the specification of the products for the

installation environment.
Check whether the power supply is matched with your

power output to avoid damage.
Make sure the wall is strong enough to withstand three

times the weight of the camera and the mounting
bracket.
If the wall is cement, insert expansion bolts before you

install the camera. If the wall is wooden, use self-
tapping screws to secure the camera.
If the product does not function properly, contact your

dealer or the nearest service center. Do NOT
disassemble the camera for repair or maintenance by
yourself.
2.2 Installation of Type I Camera
Before you start:
Both wall mounting and ceiling mounting are suitable for
the bullet camera. We take ceiling mounting as an
example in this section. You can take the steps of ceiling
mounting as a reference when adopting wall mounting.
Steps:
1. Paste the drill template (supplied) to the place where
you want to fix the camera.
2. Drill the screw holes and the cable hole in the ceiling
according to the drill template.
Lens
Bubble
Installation
Figure 2. 1 Drill Template
Power Cord
Video Cable (TVI)
Switch Button
Base Plate
Screw
Hole
Cable
Hole
(12 VDC)