Advertisement
2 Installation
2.1 Installation Preparation
Before you start:
Make sure that the device in the package is in good
condition and all the assembly parts are included.
Make sure that all the related equipment is power-off
during the installation.
Check the specification of the products for the
installation environment.
Check whether the power supply is matched with
your required output to avoid damage.
Make sure the wall is strong enough to withstand
three times the weight of the camera and the
bracket.
If the wall is cement, insert expansion screws before
installing the camera. If the wall is wooden, use
self-tapping screw to secure the camera.
If the product does not work properly, contact your
dealer or the nearest service center. Do NOT
disassemble the camera for repair or maintenance by
yourself.
2.2 Installing the Lens
Before you start:
You should purchase a lens first.
Steps:
1. Rotate the lens clockwise onto the camera module
tightly.
2. Insert the cable attached on the lens to the lens
socket to finish the lens installation.
3. Connect the corresponding power cord and video
cable.
4. Power on the camera to view the image on the
monitor.
Note:
Do not pull out the cable attached on the lens when
the power is on.
Figure 2-1 Installing the Lens
Advertisement
