Table of Contents
Advertisement
4 Inch Speed Dome Installation Manual V2.0.0
1.4 DIP Switch Settings
The dome provides a DIP switch for setting the dome address, baud rate, protocol, etc. As shown in Figure 1.2.7, ON=1, OFF=0;
positions 1-5 of DIP switch are used for setting the dome address, positions 6-7 for baud rate, positions 8-9 for parity and Manchester
code, and position 10 is for setting the connection of 120-ohm terminator. Refer to the following section for the specific settings:
As the high speed dome is capable of being self-adaptive to PELCO-D, PELCO-P and PRIVATE-Code protocols, no DIP switch
Note:
settings for control protocol are required.
1.4.1 Address Settings
The positions 1-5 of DIP switch is used for setting the dome address:
Settings for address 0~31 are listed as below:
Figure 1.2.7 DIP Switch for Address and Protocol Settings
Dome Address
1
2
0
OFF OFF OFF
1
ON OFF OFF
31
ON
ON
DIP Switch Settings
Address
1
2
0
OFF
OFF
1
ON
OFF
2
OFF
ON
3
ON
ON
4
OFF
OFF
3
4
5
OFF
OFF
OFF
OFF
ON
ON
ON
3
4
5
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
OFF
ON
OFF
OFF
9
Advertisement
Table of Contents
