Table of Contents
Advertisement
4 Inch Speed Dome Installation Manual V2.0.0
1
2
3
GN
AOU
+12V
AIN
D
T
2.
Connect the power cord, alarm in/out lines, RS485 control line and video cable, as shown in Figure 1.2.3 and Figure 1.2.4.
The high speed dome model provides 2 alarm inputs and no audio in/out; while the network speed dome model provides
Note:
audio in/out and 1 alarm input.
Operate the following steps to connect wiring:
(1)
Unplug the connector (green) from the dome circuit board.
(2)
Use the screwdriver to loosen the screw in the connector, insert the signal control line under the spring washer and finally
tighten the screw.
(3)
Plug the pin connector into the corresponding socket (green) on the circuit board.
3. Install the dome drive
(1) Insert the three ball studs into the corresponding mounting grooves by lining up the I labels both on the mounting base and
the interconnect board of dome.
(2) Rotate the dome drive for approximately 15 degrees in anti-clockwise direction until it has firmly located at the mounting
base.
(3) Tighten the Philips pan head screws on the mounting base.
4
5
6
7
8
9
10
OU
A+
B-
IN
ALA
RS48
GND
T
RM
5
1: Address and protocol settings
3: Address, baud rate and protocol DIP Switch settings
4: Network interface
Figure 1.2.4 Interconnect Board of Dome (Network Speed Dome)
Address and protocol settings
BNC analog video output
Address, baud rate and protocol DIP Switch
Network interface
Power, audio in/out, alarm in/out and RS485
port
2: BNC analog video output
5: Power, audio in/out, alarm in/out and RS485 port
7
settings
Advertisement
Table of Contents
