Table of Contents
Advertisement
4 Inch Speed Dome Installation Manual V2.0.0
1.
Configure the dome address, baud rate and other settings through DIP switch located on the bottom board of the dome drive, as
shown in Figure 1.2.3 and Figure 1.2.4. Please refer to Section 1.4 DIP Switch Settings for setting address, baud rate,
communication protocol, etc.
Figure 1.2.2 In-ceiling Mounting Base
1: Address and protocol settings
3: Address, baud rate and protocol DIP Switch settings
4: Debugging port
Figure 1.2.3 Interconnect Board of Dome (High Speed Dome)
Mounting Groove
2: BNC analog video output
5: Power, alarm in/out and RS485 port
6
Advertisement
Table of Contents
