Table of Contents
Advertisement
Model I
Model II
Figure 1. 2 Power Cable and Video Cable
Chapter 2
2.1
Installation Preparation
Before you start:
Make sure that the device in the package is in good
condition and all the assembly parts are included.
Make sure that all the related equipment is power-off
during the installation.
Check the specification of the products for the
installation environment.
Check whether the power supply is matched with
your power output to avoid damage.
Make sure the wall is strong enough to withstand
three times the weight of the camera and the
mounting bracket.
If the wall is cement l, you need to insert expansion
bolts before you install the camera. If the wall is
wooden, you can use self-tapping screws to secure
the camera.
If the product does not function properly, contact
your dealer or the nearest service center. Do NOT
disassemble the camera for repair or maintenance by
yourself.
2.2
Ceiling Mounting
Steps:
1. Stick the dill template to the ceiling.
2. Drill the screw holes, and the cable hole (optional)
in the ceiling according to the drill template.
Note:
Cable hole is required when you adopts ceiling outlet to
route the cable.
3. Loosen the torx screws to remove the upper cover
from the device.
Installation
Figure 2. 1 Drill Template
Power Cable (12 V DC)
Video Cable
Audio Cable
Video
GND
1
4
2
3
Power (12 V DC)
Audio
Advertisement
Table of Contents
