Table of Contents
Advertisement
4 Inch Speed Dome Installation Manual V2.0.0
3.2 Wall Mounting Instructions
The wall mounting is applicable to the indoor/outdoor solid wall construction which should comply with the following mounting
requirements:
The wall must be thick enough to install the expansion screws.
The wall must be capable of supporting up to 8 times the total load of the dome and its accessories.
Step1: Drill mounting holes in the wall and install the expansion screws
Drill four holes in the wall according to the mounting locations, and then insert M6 expansion screws (not supplied) into the mounting
holes.
Step2: Secure the wall mount to the wall
Fasten the expansion screws through the wall mount and gasket by using four hex nuts with flat washers to secure the wall mount to
the wall.
17
Advertisement
Table of Contents
