Removing The Trimmer Drive Pcb; Removing The Power Supply Circuit Unit - Canon Booklet Trimmer-A1 Service Manual

6.5 Removing the Trimmer Drive PCB

1) As shown in 1.3, remove the rear cover.
2) Disconnect the 9 connectors [1], and
remove the 7 supports [2]; then, detach
the trimmer drive PCB [3].
If you have replaced the trim-
mer drive PCB, be sure to adjust
VR1 (for sensitivity of detecting
a waste case full condition);
(for details, see the descriptions
on troubleshooting in Chapter
5.)

6.6 Removing the Power Supply Circuit Unit

1) As shown in 1.3, remove the rear cover.
2) Remove the 6 screws [1], disconnect the
4 connectors [2], and remove the 2
clamps [3]; then, detach the power sup-
ply circuit unit [4].
COPYRIGHT© 2002 CANON INC. 2000 CANON BOOKLET TRIMMER-A1 REV.0 FEB. 2002
CHAPTER 3 MECHANICAL SYSTEMS
F03-605-01
F03-606-01
3-41