Oparation Mode; Outline; Particulars; Making Selections - Canon Booklet Trimmer-A1 Service Manual

CHAPTER 1 GENERAL DESCRIPTION

4 Oparation Mode

4.1 Outline

The machine offers 2 operation modes listed below:
Operation Modes
"SYSTEM" mode (Default): Use it to enable/disable trimming, and to adjust the trim-
"LOCAL mode":

4.2 Particulars

Depending on the selected operation mode, differences exist in relation to the following
items:
Enabling trimming
Adjusting trimming width

4.3 Making Selections

Selections can be made in service mode. (See the descriptions for service mode.)

4.4 Others

• The language used in the trimmer's control panel can be changed only from the
trimmer's control panel.
• The language used in the trimmer's control panel is independent of the language used in
its host copier's language (i.e., there is no correlation between the two sets of specifica-
tions).
• When the machine is operating in "LOCAL" mode, the commands for "trimming" or
"trimming width adjustment" from the host copier or the driver will not be recognized,
and the operations will be as specified in the trimmer's control panel.
1-6
ming width (These settings are done in the host copier's
control panel).
Use it to enable/disable trimming, and to adjust trimming
width (Theae settings are done in the trimmer's control
panel).
"LOCAL"
Possible from trimmer's control
panel
Possible from trimmer's control
panel
T01-402-01
COPYRIGHT© 2002 CANON INC.
Operation mode
"SYSTEM"
Possible from host copier's control
panel
Possible from host copier's control
panel
2000 CANON BOOKLET TRIMMER-A1 REV.0 FEB. 2002