Pcbs; Removing The Finisher Controller Pcb - Canon Staple Finisher-R1 Service Manual

4
Parts Replacement and Cleaning Procedure > PCBs > Removing the Finisher Controller PCB

PCBs

Removing the Finisher Controller PCB

1) Remove the grate-shaped 2) Disconnect all connectors from the finisher controller PCB.
guide.
(Refer to page 4-10)
2) Release the harness from the 6 harness guides. Remove the 2 screws and disconnect the 2 connector, and then remove the
finisher controller PCB.
4 Parts Replacement and Cleaning Procedure > PCBs > Removing the Finisher Controller PCB
x12
F-4-52
x2
x2
x6
F-4-53
4-24
4-24