Figure 1.21 3.5" Disk; Figure 1.22 Disk Slot Numbers (Drive Enclosure) - Fujitsu Eternus DX60 S2 User Manual

Chapter 1 Components
1.2 Drive Enclosures
●
Part explanation
• AUTO POWER switch
The AUTO POWER switch of the drive enclosure is turned to "OFF" as the factory setting,
and should not be turned to "ON".
• MODE SELECT switch
Enables the device power to be turned on via power linkage.
The MODE SELECT switch is enabled for the factory default setting. Do not change to OFF.
• LEDs
The states of LEDs are listed below.
Table 1.8
POWER
READY
FAULT
IDENTIFY
■
Disk

Figure 1.21 3.5" disk

Figure 1.22

Figure 1.22 Disk slot numbers (drive enclosure)

ETERNUS DX60 S2 Disk storage system User's Guide -Operation-
Status and meanings of each LED (in front of drive enclosure)
LED name LED status
(green)
(green)
(orange)
(blinks orange)
(blinks blue)
(off)
DISK READY/FAULT LED
shows the slot number of each disk.
Slot#8 Slot#9
Slot#4 Slot#5
Slot#0 Slot#1
Copyright 2011 FUJITSU LIMITED
Drive enclosure status
DC power is supplied to the drive enclosure.
The ETERNUS DX Disk storage system is available for
use.
The drive enclosure is in error status.
A part of the drive enclosure requires preventive
maintenance.
As ordered via ETERNUS Web GUI, the installation
location of the drive enclosure is identified.
Slot#10 Slot#11
Slot#6 Slot#7
Slot#2 Slot#3
24
P3AM-5512-02ENZ0