Fujitsu Eternus DX60 S2 User Manual page 68

Chapter 5 Installing Optional Products
5.2 Installing Drive Enclosures
3
4
5
ETERNUS DX60 S2 Disk storage system User's Guide -Operation-
The M5 screw positions for the rack rails are determined relative to the drive enclosure
base line.
The M5 screws should be inserted in the 1st and 3rd holes above the base line.
[Left]
3rd position
2U
(M5 screws)
1st position
(M5 screws)
drive enclosure
(3)
Tighten the M4 screws of the rack rails that were slightly unscrewed in
Remove the front cover.
For details on how to attach the front cover, refer to
Cover" (page 36).
Install the drive enclosure in the rack.
CAUTION
• When installing or removing the drive enclosure to or from the
rack, make sure to have the right and left sides and the bottom
of the drive enclosure by two or more people. Failure to do so
may cause injury.
Fix the drive enclosure in the rack.
Use the two thumb screws at the front of the drive enclosure to fasten it in the rack.
Thumb screw
Copyright 2011 FUJITSU LIMITED
[Right]
3rd position
Drive enclosure
(M5 screws)
1st position
(M5 screws)
Base line of
Rack rails
"2.3 Attaching and Removing the Front
Do
(Rear rack pillars)
68
Step (1).
P3AM-5512-02ENZ0