Figure 1.14 Controller (Sas Model) - Fujitsu Eternus DX60 S2 User Manual

Chapter 1 Components
1.1 Controller Enclosure
■
SAS model

Figure 1.14 Controller (SAS model)

●
Part explanation
• LAN (RMT) port, LAN (MNT) port
These are the RJ-45 connectors to connect LAN cables. LAN (RMT) port is not used in the
EMEA&I region.
A single controller has one LAN (RMT) port and one LAN (MNT) port.
• SAS port (0 (left), 1 (right))
These are the miniSAS (SFF8088) connectors to connect miniSAS cables.
• PWC port
This port is not used.
• DI (OUT) port
This port is used to connect a controller enclosure to a drive enclosure with a miniSAS cable.
• LEDs
The states of LEDs are listed below.
Table 1.6
SCU STATUS
IDENTIFY
DI (OUT) LINKUP
ETERNUS DX60 S2 Disk storage system User's Guide -Operation-
SCU STATUS LED
IDENTIFY LED
DI (OUT) LINKUP LED
LAN (RMT) port
LAN (MNT) port
ACT LED
LINK LED
DI (OUT) port
Status and meanings of each LED (SAS model controller)
LED name LED status
(green)
(blinks green)
(blinks blue)
(off)
(green)
Copyright 2011 FUJITSU LIMITED
SAS (HOST) LINKUP/FAULT LED
SAS port (0 (Left), 1 (Right))
UNIT READY/FAULT LED
MASTER LED
PWC port
The SCU is in normal status.
SCU is charging.
As ordered via ETERNUS Web GUI, the installation
location of the controller enclosure is identified.
The link between the DI (OUT) port and the destination
has been established.
20
Controller status
P3AM-5512-02ENZ0