Fujitsu Eternus DX60 S2 User Manual page 67

Chapter 5 Installing Optional Products
5.2 Installing Drive Enclosures
■ For regions other than EMEA&I
ETERNUS DX60 S2 Disk storage system User's Guide -Operation-
(1)
Adjust the sizes of the rack rail (for left side) and the rack rail (for right side) to fit the
rack.
Loosen the M4 screws to adjust the length of the rack rails to match the distance
between the front and rear rack pillars. Leave the M4 screws slightly unscrewed, as the
rack rail must be attached to the rack before they can be completely tightened.
Rack rail (for left side)
"L" is stamped on the inner
side of the rack rail
[Left]
(for left side).
(Front rack pillars)
[Right]
(2)
Attach the rack rails to the rack.
•
•
Rack rail (for left side)
Washers
M5 screws
(Front rack pillars)
M5 screws
Copyright 2011 FUJITSU LIMITED
(Rear rack pillars)
Loosen the M4 screws, and
adjust the rack rails to the depth
of the rack.
Rack rail (for right side)
"R" is stamped on the inner
side of the rack rail
(for right side).
If the rack pillars have square (approx. 9mm) holes, screw
holders will need to be used when attaching the rack rails.
Make sure to attach the rack rails and rack pillars so that they
fit exactly together without any space between them.
Rack rail (for right side)
Washers
67
Washers
M5 screws
M5 screws
(Rear rack pillars)
Washers
P3AM-5512-02ENZ0