Figure 1.8 2.5" Type Disk; Figure 1.9 Disk Slot Numbers (2.5" Type Controller Enclosure) - Fujitsu Eternus DX60 S2 User Manual

Chapter 1 Components
1.1 Controller Enclosure
• IP RESET switch
Click once to switch the Master CM LAN port from the current controller to the other controller.
Click twice in succession within a two second interval to revert the LAN port settings of the
ETERNUS DX Disk storage system to their factory settings.
• LEDs
The states of LEDs are listed below.
Table 1.1
POWER
READY
FAULT
IDENTIFY
CACHE
■
Disk
●
For 2.5" Disk
DISK READY LED
Figure 1.8
Figure 1.9
Figure 1.9
ETERNUS DX60 S2 Disk storage system User's Guide -Operation-
Status and meanings of each LED (operation panel (controller enclosure))
LED name LED status
(green)
(green)
(orange)
(blinks orange)
(blinks blue)
(green)
(blinks green)
DISK FAULT LED
2.5" type disk
shows the slot number of each disk.
Disk slot numbers (2.5" type controller enclosure)
Copyright 2011 FUJITSU LIMITED
ETERNUS DX Disk storage system status
DC power is supplied to the controller enclosure.
The ETERNUS DX Disk storage system is available for
use.
The ETERNUS DX Disk storage system is in error
status.
A part of the ETERNUS DX Disk storage system
requires preventive maintenance.
As ordered via ETERNUS Web GUI, the installation
location of the controller enclosure is identified.
There is data in the ETERNUS DX Disk storage system
cache memory.
Data in the cache memory is saved to a non-volatile
memory.
14
P3AM-5512-02ENZ0