Fujitsu Eternus DX60 S2 User Manual page 110

Appendix A Event Notification Message List
A.2 Message List
Event type
and event
I 00000032
I 00000033
I 00000033
ETERNUS DX60 S2 Disk storage system User's Guide -Operation-
SNMP
Trap
Trap
code
No.
9 iSCSI port parameters changed (CM#%a port#%b)
IP Address $a
Subnet Mask $b
Gateway $c
iSNS Server $d
iSCSI Name $e
Alias Name $f
Host Affinity $h
Reset Scope $i
Reserve Cancel at Chip Reset $j
CHAP $k
Header Digest $l
Data Digest $m
CmdSN Count $n (This item is displayed when the CmdSN count
number is set.)
The iSCSI port parameter is changed.
%a: CM number (0 – 1)
%b: Port number (0 – 1)
$a: IP address
$b: Subnet mask
$c: Default gateway
$d: iSNS server
$e: iSCSI Name
$f: Alias Name
$h: Host affinity (Enable or Disable)
$i: Reset Scope (I_T_L or T_L)
$j: Reserve Reservation if Chip Reset (Enable or Disable)
$k: CHAP (Enable or Disable)
$l: Header Digest (CRC32C or OFF)
$m: Data Digest (CRC32C or OFF)
$n: CmdSN count number
9 Host WWN registered
No. Name WWN Host Response
$a $b $c
$a $b $c
$a $b $c
:
An FC host is registered.
$a: Host number
$b: Host name
$c: Host WWN
$d: Host response number
$e: Host response name
9 Host SAS Address registered
No. Name SAS Address Host Response
$a $b $c
$a $b $c
$a $b $c
:
A SAS host is registered.
$a: Host number
$b: Host name
$c: SAS address
$d: Host response number
$e: Host response name
Copyright 2011 FUJITSU LIMITED
Upper: Message
Middle: Detail information
Lower: Description
$d:$e
$d:$e
$d:$e
$d:$e
$d:$e
$d:$e
110
Remarks
This message is
notified when "iSCSI
Port Parameters
Changed" is
enabled for Informa-
tional Level in the
event notification
setting.
This message is
notified when "FC
Host Information
Changed" is
enabled for Informa-
tional Level in the
event notification
setting.
This message is
notified when "SAS
Host Information
Changed" is
enabled for Informa-
tional Level in the
event notification
setting.
P3AM-5512-02ENZ0