Using The Ip Reset Switch - Fujitsu Eternus DX60 S2 User Manual
Hide thumbs
Also See for Eternus DX60 S2:
- User manual (131 pages) ,
- Maintenance manual (55 pages) ,
- Hardware and software installation manual (36 pages)
Table of Contents
Advertisement
Chapter 2 Standard Operations
2.5 Using the IP RESET Switch
2.5
Using the IP RESET Switch
This section describes how to operate the IP RESET switch on the controller enclosure.
The following setting can be performed by operating the IP RESET switch:
•
Switching the Master CM
•
Restoring the LAN port settings (network environment settings) to the factory default settings.
The procedure to operate the IP RESET switch is as follows:
Procedure
1
2
ETERNUS DX60 S2 Disk storage system User's Guide -Operation-
For the dual controller model, the controller through which the
ETERNUS DX Disk storage system is set up and operated is called the
"Master CM", while the other controller is called the "Slave CM". The
single controller model only has a "Master CM" controller.
Remove the flange cover from the 2.5" type controller enclosure.
Remove the front cover from the 3.5" type controller enclosure.
For details on how to remove the flange cover, refer to
Flange Cover" (page
34).
For details on how to remove the front cover, refer to
Front Cover" (page
36).
Operate the IP RESET switch to change settings.
•
To switch the Master CM
Press the IP RESET switch once.
The MASTER LED on the controller that is set as the Master CM turns green.
•
To restore the LAN port settings (network environment settings) to the factory default
Press the IP RESET Switch twice within two seconds.
Copyright 2011 FUJITSU LIMITED
"2.2 Attaching and Removing the
"2.3 Attaching and Removing the
IP RESET
switch
40
P3AM-5512-02ENZ0
Advertisement
Table of Contents
